Power quality optimization using a novel backstepping control of a three-phase grid-connected photovoltaic systems

A novel nonlinear backstepping controller based on direct current (DC) link voltage control is proposed in three-phase grid-connected solar photovoltaic (PV) systems to control the active and reactive power flow between the PV system and the grid with improved power quality in terms of pure sinusoidal current injection with lower total harmonic distortion (THD), as well as to ensure unity power factor, or to compensate for reactive power required by the load, i.e., the electrical grid. The output power of the PV array is supplied to the grid through a boost converter with maximum power point tracking (MPPT) control and an inverter. Simulation results of the proposed controller show good robustness under nominal conditions, parameter variations, and load disturbances, which presents the main advantage of this controller as compared to an existing controller. The performance of this work was evaluated using a MATLAB/Simulink environment

A Hybrid Active Filter Using the Backstepping Controller for Harmonic Current Compensation

This document presents a new hybrid combination of filters using passive and active elements because of the generalization in the use of non-linear loads that generate harmonics directly affecting the symmetry of energy transmission systems that influence the functioning of the electricity grid and, consequently, the deterioration of power quality. In this context, active power filters represent one of the best solutions for improving power quality and compensating harmonic currents to get a symmetrical waveform. In addition, given the importance and occupation of the transmission network, it is necessary to control the stability of the system. Traditionally, passive filters were used to improve energy quality, but they have endured problems such as resonance, fixed remuneration, etc. In order to mitigate these problems, a hybrid HAPF active power filter is proposed combining a parallel active filter and a passive filter controlled by a backstepping algorithm strategy. This control strategy is compared with two other methods, namely the classical PI control, and the fuzzy logic control in order to verify the effectiveness and the level of symmetry of the backstepping controller proposed for the HAPF. The proposed backstepping controller inspires the notion of stability in Lyapunov’s sense. This work is carried out to improve the performance of the HAPF by the backstepping command. It perfectly compensates the harmonics according to standards. The results of simulations performed under the Matlab/Simulink environment show the efficiency and robustness of the proposed backstepping controller applied on HAPF, compared to other control methods. The HAPF with the backstepping controller shows a significant decrease in the THD harmonic distortion rate

DFIG use with combined strategy in case of failure of wind farm

In the wind power area, Doubly Fed Induction Generator (DFIG) has many advantages due to its ability to provide power to voltage and constant frequency during rotor speed changes, which provides better wind capture as compared to fixed speed wind turbines (WTs). The high sensitivity of the DFIG towards electrical faults brings up many challenges in terms of compliance with requirements imposed by the operators of electrical networks. Indeed, in case of a fault in the network, wind power stations are switched off automatically to avoid damage in wind turbines, but now the network connection requirements impose stricter regulations on wind farms in particular in terms of Low Voltage Ride through (LVRT), and network support capabilities. In order to comply with these codes, it is crucial for wind turbines to redesign advanced control, for which wind turbines must, when detecting an abnormal voltage, stay connected to provide reactive power ensuring a safe and reliable operation of the network during and after the fault. The objective of this work is to offer solutions that enable wind turbines remain connected generators, after such a significant voltage drop. We managed to make an improvement of classical control, whose effectiveness has been verified for low voltage dips. For voltage descents, we proposed protection devices as the Stator Damping Resistance (SDR) and the CROWBAR. Finally, we developed a strategy of combining the solutions, and depending on the depth of the sag, the choice of the optimal solution is performed